Lexmark X642e Guia do Utilizador descarregar pdf (Página 173)

173

Characters have jagged or

uneven edges.

• Change the Print Resolution setting in the Quality menu to 600 dpi, 1200

Image Q, 1200 dpi, or 2400 Image Q.

• Enable Enhance Fine Lines.

See the tables on page 175 for more settings information.

• If using downloaded fonts, verify the fonts are supported by the MFP, the host

computer, and the software application.

• Verify the print media type and print tray type settings match.

• Verify you are using the correct MFP drivers.

• Verify the environment is 16 to 32 degrees C (60 to 90

F).

Part or all of the page is

printed in black.

Check the print cartridge to see if it is installed correctly.

The job prints, but the top

and side margins are

incorrect.

• Make sure the Paper Size setting in the Paper menu is correct.

• Make sure the margins are set correctly in your software application.

Ghost images appear. • Make sure the Paper Type setting in the Paper menu is correct.

• Verify the environment is Class B.

• Replace the charge rolls.

• Replace the print cartridge.

Some of the print is cut off

on the sides, top, or

bottom of the media.

Move the guides in the tray to the proper positions for the size loaded.

Print is skewed or

inappropriately slanted.

Transparency print quality

is poor.

• Use only transparencies recommended by the MFP manufacturer.

• Make sure the Paper Type setting in the Paper menu is set to Transparency.

Problem Action

1 2 ... 168 169 170 171 172 173 174 175 176 177 178 ... 190 191

Sem comentários

Lexmark X642e Guia do Utilizador Página 173